| View previous topic :: View next topic |
| Author |
Message |
KARMAD
Padawan
Joined: 26 May 2011
Posts: 78
Location: dublin ,ireland
|
 Posted: Tue Mar 20, 2012 9:38 am Post subject: lowering torsion bar problems |
 |
|
| Hi lads hope someone here can help me.I lowered the back of my 1303 by one outer spline on one side and proceeded to do the other side .I got the spring plate off and turned up a spline,put it back on and the torsion bar is sticking out a few mil past spring plate end cap.I tried giving the torsion bar a few wacks with a hammer to no avail. Now this is my question. Do the torsion bars meet in the middle and could the side i did first be over too much and stopping the other side from pushing in? |
|
| Back to top |
|
 |
KARMAD
Padawan
Joined: 26 May 2011
Posts: 78
Location: dublin ,ireland
|
| Posted: Tue Mar 20, 2012 4:17 pm Post subject: torsion |
|
|
| Is there an allen key or something holding the inner spline end in because even with a good few hard wacks of a hammer i cant get either side out |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
