subaru bits for a conversion

beetleseb · Posted: Sun Feb 24, 2008 10:47 am Post subject: subaru bits for a conversion

Hi guys

Selling off some subaru adaptor bits

Wiring loom with ECU and manifold for a 2.2. You don't need to get the loom, cut it (huge job) and you know this one works (its still in the car) Its done by a pro (not me). The manifold also has all the bits you don't need taken off/blocked etc and has the throttlebody reverser thingy.I'll go through it with you so that you get the cold start etc right. £200

DS tuning adaptor for any EJ subaru engine (all legacy and impreza)(same as TSR apparently) 200mm clutch. Its been machined to take a vw t25 bearing to stop the clutch problems you can get with these and so the only disadvantage would be the vw starters a bit weak but it always started for me. £200

Custom Stainless Exhaust. Using RJES custom stainless manifolds and pro welded custom stainless tube. Uses a Jetex 2" backbox so easy to replace, looks perfect on a bay but should suit most, complete with lamba sensor etc. Cost me £450 to put together! £250

Any questions just let me know

Could post the exhaust and adaptor but the wiring etc would be better if picked up as its best to go through it.

Its all still in the van at the mo (bottem ends gone )but I'll take it out next weekend, so if your quick I'll take you for a spin.

Seb
_________________
Everybody is someone else's weirdo