Search found 34 matches

how about coper pipe or plastick plumbing pipe with ruber pipe at the ends

hi mate doin a great job there.
can i just ask how wide a space do you need to roll a van and how did you controll it when you rolled it (how did you roll it )

Well my bus is a tad low at the front and going round norfolk I managed to bottom out the suspension and even some of the beam/antiroll bar a fair amount, last thing I want is anything lower than the ...

hi covin where did you get that window panel from and if you don't mind me asking how much did it cost

thanks
Got the window frame from VolksHeaven in Doncaster. http://www.volksheaven.co.uk/ ...

hi covin where did you get that window panel from and if you don't mind me asking how much did it cost

thanks

hay phil you been on the club 80 90 forum lately cos your conversion kits geting a right old slaging of by some gadgy called andy .
you you should get over there mate and put him right

...

can we see the gearbox end please

hi mate do you know if they would fit late bay without mods and would they be an improvment over standard thanks.

how about removeing the cross member that the bellhousing mounts to then mounting a tube say 1.5" x 1.5" from the lugs on top of the box across the engine bay and sitting on pug mountings wi ...

i dont know if the box on the 2.1 is the same as the 1.9 so this may not aply but the 1.9 pug was not the strongest box around and have been known to spit there difs out .
recon you would be beter ...

you could have some fun with rear steering Grin

The splines are exactly 14.85mm in diameter so I'd say 15mm clearence hole is required

thank covin